TR-210 Self Stripping Liquid Release Gallon Directions: On a clean surface apply a small amount with brush, spray, or cloth. Be sure entire area is covered. Allow to dry and brush or wipe off. Excellent on nonskid, grained or sand type finishes. Repeat as re Liquid mold release is recommended for use on fully cured, well conditioned molds only. It is not recommended on new or reconditioned molds until eight or ten parts have been pulled using paste wax. It should not be used as a final coat over paste wax as the high solvent content is provided to remove wax and wax build up. Rapid settling of liquid waxes requires shaking before and during each use. Each user is encouraged to prepare a test part for his or her particular application. |
TR-210自动剥离液体释放加仑
使用方法:在清洁的表面上，用刷子、喷雾或布涂抹少量。确保覆盖整个区域。晾干后刷掉或擦掉。优异的防滑，颗粒或砂型饰面。按照要求重复。液体脱模建议仅用于完全固化、条件良好的模具。不建议在新的或翻新的模具上使用膏蜡拉出8或10个零件。它不应该用作膏蜡的*后一层，因为高溶剂含量是用来去除蜡和蜡积聚的。液体蜡的快速沉淀需要在每次使用前和使用过程中摇动。鼓励每个用户为他或她的特定应用准备一个测试部件。